Contacts
Address
India, Maharashtra, Thane, 400710, Thane-Belapur Road
Phones of enterprise
management
+91
When placing an order please inform the manager that you've learned the information on Allbiz! Thank you that you buy on Allbiz!
Internet
Site:
About enterprise
Polyrub Extrusions (India) Pvt. Ltd.
We are manufacturers of leading two wheeler of India such as Honda, TVS, Mahindra, Bajaj, Hero motor corp, etc. Beside this We exports our products to Trumpt Motorcycle Thailand also.
Developed in house technology for cellular (sponge) rubber profiles in1985
Developed the co- extrusion process for twin layer hoses and started production in 1986
Have a technical tie up since 2006 with Yamashita rubber Japan for Honda cars
New facility being developed at Cahakan , Pune fully operational from 2007.
Developed in house technology for cellular (sponge) rubber profiles in1985
Developed the co- extrusion process for twin layer hoses and started production in 1986
Have a technical tie up since 2006 with Yamashita rubber Japan for Honda cars
New facility being developed at Cahakan , Pune fully operational from 2007.
We are planning to operate from Hosur Tamil Nadu by April end as well as Ahmadabad Gujarat also by the end of 2015.
In stock
These are multilayer hoses normally with an impermeable inner layer of fluoroelastomer with following layers of epichlorohydrin, subsequently braided with aramid and again covered with a heat, ozone resistant layer. These are obviously lower diameter hoses that withstand pressure of a maximum 60...
Group: Pipes, tubes, hoses and fittings made of plastic
In stock
NORMALLY PRODUCED FROM EPDM TERPOLYMERS TO WITHDRAW TEMPERATURES UP TO 150°C. THE REINFORCEMENT CAN VARY DEPENDING ON TEMPERATURE AND PRESSURE REQUIREMENTS. THE REINFORCEMENT COULD BE RAYON, POLYESTER OR ARAMID. ARAMIDS ARE USED FOR HIGH-END REQUIREMENTS OF TEMPERATURE AND PRESSURE.
CONSTRUCTION -...
Group: Hoses for car cooling system
In stock
These are multilayer hoses normally with an impermeable inner layer of fluoroelastomer with following layers of epichlorohydrin, subsequently braided with aramid and again covered with a heat, ozone resistant layer. These are obviously lower diameter hoses that withstand pressure of a maximum 60...
Group: Pipes, tubes, hoses and fittings made of plastic
In stock
These are multilayer hoses normally with an impermeable inner layer of fluoroelastomer with following layers of epichlorohydrin, subsequently braided with aramid and again covered with a heat, ozone resistant layer. These are obviously lower diameter hoses that withstand pressure of a maximum 60...
Group: Pipes, tubes, hoses and fittings made of plastic
In stock
These are multilayer hoses normally with an impermeable inner layer of fluoroelastomer with following layers of epichlorohydrin, subsequently braided with aramid and again covered with a heat, ozone resistant layer. These are obviously lower diameter hoses that withstand pressure of a maximum 60...
Group: Pipes, tubes, hoses and fittings made of plastic
In stock
NORMALLY PRODUCED FROM EPDM TERPOLYMERS TO WITHDRAW TEMPERATURES UP TO 150°C. THE REINFORCEMENT CAN VARY DEPENDING ON TEMPERATURE AND PRESSURE REQUIREMENTS. THE REINFORCEMENT COULD BE RAYON, POLYESTER OR ARAMID. ARAMIDS ARE USED FOR HIGH-END REQUIREMENTS OF TEMPERATURE AND PRESSURE.
CONSTRUCTION -...
Group: Hoses for car cooling system